In this paper, electrospinning technique has been employed to synthesize In2O3/PVP (indium oxide/polyvinylpyrrolidone) composite fibers. The produced In2O3 fibers after annealing at 600 C were investigated as sensitive layer in resistive sensors for monitoring NO2 at low concentrations in air. By optimizing the spinning conditions and the subsequent annealing treatment, In2O3 fibers have been successfully obtained. The annealed samples have a high crystallization degree. Their sensing behavior towards nitrogen dioxide has been then tested both in the dark and under UV light. To analyze in detail the effect of UV radiation, sensing tests have been performed by using three different procedures: without UV illumination, under continuous UV illumination, and under pulsed UV illumination (provided only during the recovery time). It has been proved that the optimal sensing characteristics (higher sensibility and very shorter recovery time) of the sensor occur when the sample is irradiated with pulsed UV light.

UV effect on indium oxide resistive sensors

NERI, Giovanni
2014-01-01

Abstract

In this paper, electrospinning technique has been employed to synthesize In2O3/PVP (indium oxide/polyvinylpyrrolidone) composite fibers. The produced In2O3 fibers after annealing at 600 C were investigated as sensitive layer in resistive sensors for monitoring NO2 at low concentrations in air. By optimizing the spinning conditions and the subsequent annealing treatment, In2O3 fibers have been successfully obtained. The annealed samples have a high crystallization degree. Their sensing behavior towards nitrogen dioxide has been then tested both in the dark and under UV light. To analyze in detail the effect of UV radiation, sensing tests have been performed by using three different procedures: without UV illumination, under continuous UV illumination, and under pulsed UV illumination (provided only during the recovery time). It has been proved that the optimal sensing characteristics (higher sensibility and very shorter recovery time) of the sensor occur when the sample is irradiated with pulsed UV light.
2014
9783319006833
File in questo prodotto:
Non ci sono file associati a questo prodotto.
Pubblicazioni consigliate

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11570/2685968
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 0
  • ???jsp.display-item.citation.isi??? ND
social impact