In this work composite materials, based on quartz fibers and epoxy resins, were employed with the aim to restore damaged teeth. The composite materials were chosen because they show biomechanical features very similar to that of the dentine, the main constituent of the tooth. Extracted teeth were rebuilt with two different restorative procedures: in the first, the composite material was pre-formed in a conical trunk shape abutment (PA) and then bonded to a fiber quartz post with a dental bonder. In the second rebuilt system the abutment was prepared by cross linking the resin on the fiber quartz post with a halogen lamp (CRA). The restored teeth were then mechanically tested and observed with a Scanning Electron Microscope (SEM) with the aim to study the interaction between the reconstructive materials. Wetting and roughness measurements were also carried out in order to study the interface adhesion between the post and the abutments. Characterization analysis evidenced that the CRA restorative procedure improves the adhesion between the substitutive materials and shows higher fracture strength than the PA ones. Anyway both the rebuilt systems are able to support the masticator load. An explanation of the interfacial post-abutment interaction phenomenon is discussed.
Mechanical behavior of quartz fiber reinforced epoxy resins for teeth restoration
VISCO, Annamaria;CALABRESE, Luigi;CAMPO, NINO;TORRISI, Lorenzo;OTERI, Giacomo;LO GIUDICE, Giuseppe;CICCIU', Domenico
2006-01-01
Abstract
In this work composite materials, based on quartz fibers and epoxy resins, were employed with the aim to restore damaged teeth. The composite materials were chosen because they show biomechanical features very similar to that of the dentine, the main constituent of the tooth. Extracted teeth were rebuilt with two different restorative procedures: in the first, the composite material was pre-formed in a conical trunk shape abutment (PA) and then bonded to a fiber quartz post with a dental bonder. In the second rebuilt system the abutment was prepared by cross linking the resin on the fiber quartz post with a halogen lamp (CRA). The restored teeth were then mechanically tested and observed with a Scanning Electron Microscope (SEM) with the aim to study the interaction between the reconstructive materials. Wetting and roughness measurements were also carried out in order to study the interface adhesion between the post and the abutments. Characterization analysis evidenced that the CRA restorative procedure improves the adhesion between the substitutive materials and shows higher fracture strength than the PA ones. Anyway both the rebuilt systems are able to support the masticator load. An explanation of the interfacial post-abutment interaction phenomenon is discussed.Pubblicazioni consigliate
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.